Differences

This shows you the differences between two versions of the page.

--- epaper_display [2011/02/24 15:03]
steve_m [Driving the Motorola F3 e-paper display] sustain->retain
+++ epaper_display [2011/02/24 17:09]
steve_m [Interfacing with the display]
@@ Line 16: / Line 16: @@
 \\ By the way, since I mentioned the TI Locosto baseband: Maybe someone wants to reverse-engineer the [[http://bb.osmocom.org/trac/wiki/CalypsoRomloader#secure-RomloaderonCalypsoplus|serial rom-bootloader]] of this ARM7-based processor, so we can drive the display directly from the phone :-P
 ===== Interfacing with the display =====
-Normally, the baseband board and the display/keypad pcb are connected with a 32-pin connector (exact model unknown). Luckily there are pull-up resistors and capacitors for every needed signal, so I decided to solder some wires there, instead of directly to the connector. The schematics of this phone are floating around the web (just search for **f3_schem.rar**).
+Normally, the baseband board and the display/keypad pcb are connected with a 32-pin connector (exact model unknown). Luckily there are pull-up resistors and capacitors for every needed signal, so I decided to solder some wires there, instead of directly to the connector. The schematics of this phone are floating around the web, just search for **f3_schem.rar**.
 |{{:f3_wires_soldered.jpg?350|thin wires soldered to the display pcb}}|{{:f3_display_connector.jpg?436|the connector of the display}}|

steve-m.de wiki